Emergency Plumbing in Irving, TX

Most after-hours emergency calls in Irving start around $150 for the service call itself and run up toward $500 depending on timing, with total job cost depending on what's actually wrong — a simple drain clear stays near the low end, while a slab leak repair can run $2,000 to $6,000 or more. Emergency Plumber Irving coordinates a written quote before any work starts, with no overnight or holiday surcharge added after the fact. We're open 24 hours a day, so a 2 a.m. call gets the same upfront-quote process as a Tuesday afternoon one. Call (469) 599-2691 for a real number before a technician is dispatched.

Watch for a water bill that jumps without explanation, warm spots on the floor, running-water sounds when every fixture is off, or a meter that keeps spinning with the house shut down. Irving sits on expansive clay with a plasticity index commonly measured at 40 to 60-plus, so even a small leak saturates the soil and shifts the slab fast. A crack as small as one-eighth of an inch in a pipe can release over 250 gallons a day. The plumbers we coordinate use electronic leak-detection equipment to pinpoint the leak before anyone cuts into the slab, usually in 1 to 2 hours.

A tank that's rusty at the base, popping or rumbling sounds from sediment buildup, lukewarm water, or a pilot light that won't stay lit are all signs a water heater is failing. Conventional gas storage tanks typically last 8 to 12 years and electric tanks 10 to 15, while tankless units run 15 to 20-plus years with maintenance. The water heater repair team we coordinate can often extend a tank's life with a flush and element swap, but once it's rusting, a Rheem, A.O. Smith, or Bradford White replacement is the safer call. Most replacements finish same-day, in 2 to 4 hours.

A traditional open-trench sewer line replacement takes 2 to 5 days and digs a trench the length of the damaged run, while trenchless methods finish the same repair in 1 to 2 days through small access pits. Cast-iron lines in Irving's older blocks are frequent trenchless candidates once a camera inspection confirms the pipe path, in 30 to 60 minutes. Our [sewer line repair](/sewer-line-repair) coordination runs that inspection first, and trenchless usually wins on total cost once landscaping and driveway repair are factored in.

Hydro jetting is safe for most modern PEX, copper, and PVC lines, but it takes care on older cast-iron pipe, which shows up often enough in Irving's 1970s-80s housing stock. The plumbers we coordinate run a camera inspection first to check pipe condition rather than jetting blind. A standard hydro-jetting job takes 1 to 3 hours and clears grease, roots, and scale a cable auger can't touch. When a line is too deteriorated for jetting, we'll recommend [drain cleaning](/drain-cleaning) by cable auger or a spot repair instead — high-pressure water through a failing pipe just creates a bigger leak.

Shut off the water at the main shutoff valve first — usually near the water meter or where the line enters the house — then call (469) 599-2691 so a technician can be routed while you deal with the mess. If it's safe, cut power to any outlets or fixtures near standing water and move valuables out of the way. A crack as small as one-eighth of an inch can release over 250 gallons a day, so minutes matter. Most [emergency plumbing](/emergency-plumbing) burst-pipe repairs finish in 1 to 3 hours once a technician arrives, and we're open 24 hours a day for exactly this call.

Texas law requires a licensed plumber for any work touching a water supply or drain line, through the Texas State Board of Plumbing Examiners, which regulates Tradesman, Journeyman, Master Plumber, and Plumbing Inspector tiers statewide. A Journeyman license requires 8,000 verified hours under a Responsible Master Plumber, and only a Master Plumber can hold that RMP role. We coordinate plumbers rather than run a single in-house crew, and any technician's status can be checked directly at tsbpe.texas.gov before work starts.

Yes — we cover [Las Colinas](/las-colinas) and [Valley Ranch](/valley-ranch), both fully inside Irving's city limits and permitted through Irving's Building Inspections Department, plus [Coppell](/coppell-tx), its own incorporated city with a separate Building Inspections Department at 265 E. Parkway Blvd. Coppell also requires a floodplain development permit for work touching the Denton Creek, Grapevine Creek, Cottonwood Creek, or Elm Fork corridors. Valley Ranch is a notable quirk — it sits inside Irving for permitting but is served by Coppell ISD schools rather than Irving ISD. We handle the paperwork for whichever office applies.

Leave the house immediately without flipping light switches or using anything that could spark, then call your gas utility's emergency line from outside before calling us for the repair. Once the utility confirms it's safe to re-enter, the plumbers we coordinate run a pressure test and locate the leak, typically in 1 to 2 hours. Common causes in Irving homes include a loose fitting at a water heater or range connection and, in older houses, corrosion at an aging joint. Never try to locate a suspected gas leak yourself — the first call goes to the utility, not the plumber.

A tank water heater stores and reheats 30 to 50 gallons and typically lasts 8 to 12 years, while a tankless unit heats water on demand and lasts 15 to 20-plus years with maintenance. Tankless installation runs $2,500 to $6,500 versus $1,200 to $3,500 for a tank replacement, but tankless can be 24% to 34% more efficient for households using 41 gallons or less of hot water a day. Either option needs a plan for Irving's clay-driven ground movement, since a shifted slab can stress the lines feeding it. The [water heater repair](/water-heater-repair) team we coordinate walks every homeowner through both options.